Manual

12
Important Parts of the Firearm (cont’d)
The Torch Cam™ Breech Block.
TO OPEN THE TORCH CAM™ BREECH BLOCK
1. Grasp the firearm with your left hand beneath the receiver. (See Picture 6).
2. Lift the Torch Cam™ breech block up with your right hand and swing the breech block counter clockwise to the
shooter’s left side of the firearm. (See
Picture 7).
3. The breech plug is now visible and accessible for priming
TO CLOSE THE TORCH CAM™ BREECH BLOCK
1. Grasp the firearm with your left hand beneath the receiver. (See Picture 6).
2. Rotate the Torch Cam™ breech block clockwise toward the shooter’s right side of the firearm. (See
Picture 8).
3. Press down firmly on the grooved edge of the Torch Cam™ breech block to lock it into place.
(See
Picture 9). You should hear an audible click and feel the detent ball lock into place. The Torch Cam™
breech block must be locked into place to fire the firearm.
The Breech Plug.
The breech plug holds the 209 primer used to ignite
the powder charge. The breech plug is located at the
rear of the barrel and is exposed by opening the
Torch Cam™ breech block. (See
Picture 10).
The br
eech plug is installed at the factor
y but should
be r
emoved and thoroughly cleaned along with the
barrel prior to firing the muzzle loading rifle for the
first time in order to remove any residual rust
preventives applied at the factory. To remove the
breech plug, follow the instructions below. To clean
the bar
r
el, follow the instr
uctions listed on pages 23 and 24.
Pictur
e 10
Picture 6 Picture 7
Picture 8 Picture 9