Operation Manual

C GETTING STARTED

It is recommended that you use your new shaver daily for up to four weeks to

allow time for your beard and skin to become accustomed to the new shaving

system.

, CHARGING YOUR SHAVER

• Ensure the product is switched o.

• Connect the shaver to the adapter and then to the mains.

• When charging a square pattern will cycle around the display.

• Charge for at least 24 hours when using for the rst time.

• Once the shaver batteries are fully charged, the display will ash “60”.

• Use the product until the battery is low as indicated by the digital display

showing “Lo”.

• To preserve the life of your batteries, let them run out every 6 months then

recharge for 24 hours.

• When empty, the battery will be charged within 120 minutes

• The shaver automatically adjusts to a mains voltage between 100V and

240V.

, CORDED USE

• Connect the shaver to the adaptor, then to the mains and recharge for 5

minutes before use.

, CAUTION

• Extended mains only use will result in the reduction of the battery life.

F INSTRUCTIONS FOR USE

, SHAVING

• Make sure your shaver is properly charged.

• Switch the shaver on.

• Stretch the skin with your free hand so the hairs stand upright.

• Hold the shaving head so that the foils touch your face.

• Use short, linear strokes.

, TRIMMING

• Switch the appliance on.

• Push the trimmer release button.

• Hold the trimmer at a right angle to your skin.