Operation Manual

TO REPLACE THE CUTTERS

Grasp cutter between thumb and foreﬁ

nger and pull upward.

Snap both new cutter assemblies into top of oscillator tips.

Note:

Do not press on the cutter ends as this may cause damage.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE,

OR INJURY TO PERSONS:

An appliance should never be left unattended when plugged in to a power outlet, except

when charging. Keep the power adaptor and cord away from heated surfaces.

Make sure the power adaptor and cord do not get wet.

Do not plug or unplug the shaver with wet hands.

Do not use the product with a damaged cord. A replacement can be obtained via the

Remington

Service Center.

Charge, use and store the product at a temperature between 15°C and 35°C.

Always unplug from the mains when cleaning or when being used under running water.

Only use parts supplied or recommended by Remington

Keep this product out of reach of children. The use of this appliance by persons with

reduced physical, sensory or mental capabilities or lack of experience and knowledge can

give cause to hazards. Persons responsible for their safety should give explicit instructions

or supervise the use of the appliance

ENGLISH

080621_REME_IFU_FF500_FF600_inneGB_5 GB_5080621_REME_IFU_FF500_FF600_inneGB_5 GB_5 08.28.2008 7:25:42 Uhr08.28.2008 7:25:42 Uhr

Replacement model F4790 :

SP-290

TO REPLACE THE FOIL

Pull the foil assembly up to remove from the hair pocket.

Insert new foil assembly in hair pocket until it snaps in place.

Spare Parts

F5790 :

SP-390

F6790-F7790 :

SP-399

TROUBLESHOOTING

If your shaver battery is completely empty or the shaver has not been used for an

extended period of time, the shaver may not start when operated using the cord. If this

occurs, charge the shaver for approximately 15 sec. before shaving.

Your shaver should be mainly used in cordless mode and only recharged when battery

charge is low. Extended mains only use or continuous connection to the mains will result in

the reduction of the battery life.