Operation Manual

5
E Tips for best results
• Always hold the shaver at right angles to the skin so that all foils are
touching the skin with equal pressure.
• Usemoderatetoslowstrokingmovements.Theuseofshortlinearmotions
in stubborn areas may obtain a closer shave, especially along the neck and
chin line.
• DONOTpresshardagainsttheskininordertoavoidirritationanddamage
to the foil heads.
C CLEANING AND MAINTENANCE
, DRY CLEANING
• Remove the foil assembly by pressing the foil assembly release buttons on
both sides of the head and lifting the assembly upwards from the hair
pocket
• Gently tap out the excess hair shavings and use a cleaning brush to clean
out the hair pocket if necessary.
• Do not use a brush to clean the shaving foils.
• Replace the head assembly.
, REPLACING THE FOILS & CUTTERS
• To ensure continued high quality performance from your shaver, we
recommend the foils and cutters are replaced regularly.
, Signs that your foil/s and cutter/s need replacing
• Irritation: as foils get worn, you may experience skin irritation.
• Pulling: as the cutters wear, your shave may not feel as close and you may
feel the cutter pulling your hair.
• Wear through: you may notice that the cutters have worn through the foils.
, TO REPLACE THE FOIL
• Remove the foil assembly by pressing the foil assembly release buttons on
both sides of the head and lifting the assembly upwards from the hair
pocket.
• Insert the new foil assembly on the hair pocket, press down and click into
place.
, REPLACING THE CUTTERS
• Grasp the cutter between your thumb and forenger and pull upwards.
• Snap the new cutter into the oscillator tip.
, Note: DO NOT press on the cutter ends as this may cause damage.
• Foil and cutters replacement model: SP62