Operation Manual

6 Fault messages

A fault message is given by the green status LED. This is indicated by the following

flash patterns:

1. The LED first flashes on for 1 second ( ) and then off for 0.5 seconds ( ).

2. The LED then flashes a number of times as indicated in the table below to signify

the fault.

3. Thereafter, the LED is off for at least 0.5 seconds.

This ﬂash pattern is repeated each time.

6.1 Fault messages green status LED

Fault indication Green status LED ﬂashes as follows:

Problem No connection with

iSense RF.

Solution

- Check whether the iSense RF indicates a fault or is on.

- Try to re-establish the connection between the iSense RF and

the Base station; see Chapter 5.

- If this does not solve the problem, relocate the iSense RF or the

Base station

or remove obstacles that can interfere with the RF

signal; see paragraph 3.1.

T001500-B