Operation Manual

8
2-Channel time clock
4.1 Setting Operation Modes
Operation Mode Position of the sliding switch
Permanently ON
The appliance(s)
connected is/are
permanently
switched ON
• Set the left sliding switch to position 1.
• Choice of Channel is effected using the Skip button „X->“.
Set Channel:
Channel 1 (CH): press once
Channel 2 (DHW): press twice
Channel 1 and 2: First select Channel 1 or 2. Then press the Skip button again to select the second
Channel.
The selected Channel number(s) show in the display.
The lamp symbol ☼ appears as soon as at least one Channel has been selected.
• To delete a selected Channel set the left sliding switch for 2-3 seconds to AUTO and then back to I.
The permanently ON Channel can be selected again.
Permanently OFF
The appliance(s)
connected is/are
permanently
switched OFF
• Set the left sliding switch to position O.
• Choice of Channel is effected using the Skip button „-X->“.
Set channel:
Channel 1 (CH): press once
Channel 2 (DHW): press twice
Channel 1 and 2: First select Channel 1 or 2. Then press the Skip button again to
select the second Channel.
The selected Channel number(s) show in the display.
• No ☼ symbol.
• To delete a selected Channel set the left sliding switch for 2-3 seconds to AUTO and then back to 0.
The permanently OFF Channel can be selected again.
AUTO
The appliance(s)
connected switch
according to a pre-
set programme
• Set the left sliding switch to position AUTO.
• No Channel selection is possible in this setting – both Channels switch according to how they have
been programmed.
• ON mode: symbol ☼ and the relevant Channel number(s) show up in the Display.
• OFF mode: symbol ☼ disappears.
table 04 Setting modes
4.1.1 Setting the Time and Day
Proceed as follows:
• Set the right sliding switch to position RUN and next press
buttons „h“ and „m“ simultaneously for 2 to 3 seconds (Set
function).
• Press button „1...7“ to input the day of the week (1 = Mon-
day, 7 = Sunday). An arrow will be seen in the Display
indicating the day of the week.
• Use buttons „h“ and „m“ to set the time.
• After 15 seconds the times will automatically pick up the
time of day. (The colon in the Display will start to flash.)
Or set the right sliding switch briefly to P1 or P2 and then
back to RUN. The time of day will be activated immediately.