User's Manual

V1.0
Sensor Wire Screw Terminal Connector Installation
The RelyanceHub is supplied with screw terminal connectors that plug into the
terminals on the rear of the RelyanceHub. There are two types of input ports. The 4-pin
inputs provide a status input connection and +12 Vdc for powered sensors. The 2-pin
ports provide only status inputs. If more than 4 sensors require power, the sensor power
wires can be doubled-up on one or more of the 4 power ports.
Strip 4 mm from the end of the wire, insert it into the connector and tighten the screw
firmly.
4 mm
1
2
4 mm
1
4
Power Wire Connector Installation
To prevent serious injury and/or equipment damage, before attempting to install
the power connector on the wire verify that the powere source is 24-30 Vdc/AC
and that the power is turned off.
The power connector provided is a screw terminal type connector similar to those used
for the input ports, but it is larger and black to prevent accidental insertion in an input
port. The wires are installed in a similar manner.
4 mm
Once the power connector is installed the power can be restored.