Operation Manual

ENGLISH
79
4.1.4 Timecode
In this detailed timecode menu several adjustments for player 1 and player 2 can be carried out
although they are not necessary if the easy setup was successful. You should carry out advanced
settings for optimazation and solving problems only.
1. Timecode from
Here you can set the timecode source, vinyl or CD.
2. Spin! Mode
HereyoucanselecttheSpin!mode(seechapter2,item-33-).
3. Audio Device
Here the ASIO driver should be selected.
4. Audio Source
Here you can assign the corresponding connections of your Spin! 2 interface.
The default settings are:
•Player1:0:ReloopSpin!-Interface1–ReloopSpin!-Interface2
•Player2:2:ReloopSpin!-Interface3–ReloopSpin!-Interface4
5. Timecode Quality
Here the timecode‘s signal quality is displayed in percentages. Fluctuations or a percentage that is
toolowcouldbecausedbydirtyorwornoutneedles.Ideallythevalueshouldbebetween90–100%.
6. Adjust Gain
Here the decibel value of the input signal for the left and right side can be adjusted. The virutal LED
chain serves as modulation display. This value should only be changed manually when trying to solve
aproblem.Intheeasysetuptheidealgainvaluewillbeconguredautomaticallyforyou.
1
2
3
4
5
7
8
9
10
11
12
15
13
18 17 14 16
6