Operation Manual

ENGLISH

a) Connect your turntable‘s or CD player‘s outputs to the corresponding inputs (1 or 2) of the

Reloop Spin! 2 Interface -1-. If required connect your turntables to the GND grounding screw -3-.

Depending on the connected player de-/activate the phono pre-amp.

b) Connectthelineoutputs-6-oftheSpin!2Interfacewiththelineinputsofyourmixer.Inorderto

loop through a conventional vinyl signal connect the Through Outputs -7- with the phono inputs

of your mixer. This way it is possible to switch between the timecode and analogue vinyl signal by

simply using the phono/line switches.

NOTE!

The Signal Input LEDs 1, 2 -8- light up when there is an incoming signal. The Signal Output

LEDs light up when there is an outgoing signal.

c) ConnecttheenclosedUSBcordtotheUSBPort-4-ofyourSpin!2InterfaceandafreeUSBport

ofyourcomputer.Nowthefollowingmessagesshouldappearonyourmonitor(exampleforXP):

(Newhardwarefound–ReloopSpin!2Interface)

(Newhardwarefound–USBaudiodevice)

(Newhardwarefound–Yournewhardwareisinstalledandreadytouse.)

NOTE!

The basic installation of your Spin! 2 Interface under Windows XP & Vista is carried out as Plug

‚N‘ Play without the need for special drivers.

CONNECTIONS