Instruction Manual
Use the Bank Programme function -9- to play a sequence of loops saved on the banks. If loops have
been saved on the sample banks, activate the Bank Programme function with the Bank Programme
button -9-.
>> For details on how to save loops, go to the chapter entitled „Sampling“. The display indicates
„Bank P01“. By pressing the Cue/Sample Buttons 1 to 4 -15- in any sequence, an individualised se-
quence of up to 12 samples can be programmed.
Activate the Reverse function -10- to play the track in reverse. The LED is on. Press the button again
to deactivate this effect. The LED goes off.
The Display -11- indicates all important functions of the player:
Indicates the number of the current track or folder (folder for MP3-CD).
Indicates if the player shows the elapsed time of a track (nothing on display), the remaining time of
a track (the display reads „Remain“) or the remaining time of the entire CD (the display reads „Total
Remain“). Use the Time Button -7- to switch between the modes.
Indicates the time in the chosen Time mode in minutes, seconds and frames (1/75 min.).
Visualises the time display and increases or decreases, depending on the Time mode. Shortly before
a track ends, the entire bar ashes.
Indicates how much music is saved in the Anti-Shock Memory and if the Instant Start function is
available. „19“ is the maximum memory value and represents 10 seconds for the anti-shock memory.
Indicates the set pitch value of a track in percent.
Indicates if Key Lock has been activated (shows the padlock symbol). If Key Lock is activated, the
track‘s tone pitch remains the same when the tempo changes.