Operation Manual
In the selection screen open the mapping le that is found on the CD or that was downloaded from
the Reloop support site.
Should a problem arise and Mixage‘s LEDs are not lit correctly, this is probably caused in most
cases by installed MIDI software (e.g. MidiYoke, Maple Virtual MIDI Cable, etc.).
In order to solve the problem proceed as follows:
1. In Traktor open the adjustment dialogue by clicking the small cog wheel in the upper right corner.
2. Open the category „Controller Manager“.
3. For the following device entries the following port assignments have to be congured:
After connecting and conguring Reloop Mixage correctly for the DJ software, Traktor can now be used.
Mixage V* Reloop Mixage Reloop Mixage
Function with activated Shift -T3-
T1
Allows the temporary deceleration (counter-
clockwise) of a track.
T2
Allows the temporary acceleration (clockwise)
of a track.
T3
By pressing this button all the device‘s con-
trol elements receive a different function. The
current assignment can be viewed on the right
side of this chart.
T4
Sets an automatic loop with the set loop length
(-T15-), without the necessity of setting the
loop ending point manually.
Manually sets the starting point of
a loop. Simultaneously a cue point
will be dened.
T5
By turning the encoder the set loop‘s length
can be varied.
By pressing the encoder the loop active func-
tion can be activated and deactivated respec-
tively.
Carries out a beatjump in or oppo-
sed to playback direction
T6
Preamplication of a track/deck.
T7
Herewith it is possible to exactly adjust the
pitchfader of the current deck. In 0% position
the LED is illuminated.
T8
Jumps to the last stored loop and reactivates it.
Manually sets the ending point
of a loop. Now the deck is in loop
mode; the selected passage will
be repeated continuously. Rene-
wed pressing stops the loop mode.