Operation Manual

18
ENGLISH
B24. Auto Loop Button
With the Auto Loop function you can set an automatic loop with the push of a button without
having to set the loop ending point manually. The desired bar length can be adjusted beforehand.
Shift: Auto Loop Deck C/D. [Traktor PRO]
Note!
By holding the shift button and turning the Dry/Wet Encoder -B30- you can vary the auto bar
length.
B25. Loop Active Display
If a loop is active this button will be illuminated.
Shift: FX Select (Advanced Mode). In Advanced Effect mode you can switch through the effects
by using this button. [Traktor PRO]
B26. FX/Value 1-3 Encoder [Traktor PRO]
Depending on the chosen effect it is possible to adjust the parameters 1-3 with this controller.
Shift: FX Select 1-3. In Chained Effect mode you can choose the effects for banks 1-3 with the
encoders. [Traktor PRO]
B27. Activate 1-2 Buttons
Depending on the selected effect you can activate parameter 1 or 2 with these buttons.
B28. Activate 3 Button [Traktor PRO]
Depending on the selected effect you can activate parameter 3 with this button.
Shift: FX 1. With this functoin it is possible to assign and activate the effect bank for player A.
[Traktor PRO]
B29. FX On Advanced Mode
By using this button in advanced effect mode you can activate the effect.
Shift: FX 2. With this function it is possible to assign and activate the effect bank for player B.
[Traktor PRO]
B30. Dry/Wet Encoder
With the Dry/Wet encoder the effect rate can be faded in and out.
Shift: Loop +/-. By holding the shift button and simultaneously turning the Dry/Wet Encoder it is
possible to vary the Auto Loop bar length.
B31. Master Volume
With this controller the master output volume can be adjusted.
B32. Headphones Volume
With this controller the headphones volume can be adjusted.
B33. Cue Mix Fading
With the Cue Mix controller you can simulate a pre-mix via the headphones. In the right position
you can hear the master signal and in the left position you can hear the cue signal.
B34. Kensington Lock
Standardized connection for theft protection.
B35. 6.3 mm Microphone Jack
You can connect a microphone with a 6.3 mm jack to this input.
B36. Microphone Equalizer
With this equalizer it is possible to adjust the microphone‘s sound characteristics.
B37. Record Gain
Adjust the record level via this controller.
B38. 6.3 mm Headphones Input
You can connect headphones with a 6.3 mm jack to this input.
B39. Headphones Equalizer
With this equalizer it is possible to adjust the headphones‘ sound characteristics.
B40. Crossfader Curve
With this controller you can adjust the crossfading curve. The curve is steplessly adjustable from
a constantly increasing curve up to a hard adjustment.
B41. Mains Cord Strain Relief
With this the cord will be relieved from strain.
B42. Mains Connection
You can connect the Digital Jockey 2‘s mains adapter to this connection.
B43. On/Off Button
With this button ou can turn the Digital Jockey 2 on and off respectively.
B44. USB Port
Connect your USB cord to this input.