User Manual
There are a few settings and tests which can be carried out directly with Contour without the need
for a computer. In the following a few points will be explained more thoroughly.
Should you, however, wish to assign the decks to the MIDI channel combination 5-8, 9-12, or 13-16
proceed as follows.
1. Make sure that Contour is turned off (see ON/OFF Button -B36-).
2. Press and hold the Shift Button -T29- and turn on Contour via the ON/OFF Button -B36-.
3. Now release the Shift Button -T29-.
4. via the FX Buttons -T1 – T4- you can select the desired channel combination.
5. By pressing the Shift Button -T29- one last time the selection is saved and the Controller will
be rebooted. The new MIDI channels have now been determined.
Should the Jog Wheel -T28- not react correctly any more, its touch-sensitivity can be recalibrated.
Proceed as follows.
1. Make sure that Contour is turnd off (see ON/OFF Button -B36-).
2. Press and hold the Play/Pause Button -T32- and turn on Contour via the ON/OFF Button -B36-.
3. Now release the Play/Pause Button -T32-.
4. Then touch the Jog Wheel‘s -T28- metal surface. Simultaneously the feedback LEDs that are
placed around the Encoder -T7/9- should go out from the right to the left.
5. Release your nger from the surface and in the following press the Play/Pause Button -T32- in
order to complete the calibration procedure. The controller will automatically reboot.
1 - 4 1
5 - 8 2
9 - 12 3
13 - 16 4