User Manual



T16 
By turning the encoder a set loop can
be shifted.
Simultaneously pressing and tur-
ning the encoder determines the
movement‘s range.

Allows the temporary acceleration (clockwise)
or deceleration (counterclockwise) of a track.
T17 
Regulates the lter effect for the active
deck. In the zero position the lter will
be deactivated automatically.

Via the Cue Mix Fader a pre-mix can be simula-
ted in your headphones. When to the right the
master signal is audible, when to the left the
cue signal is audible.
T18 
Herewith you can adjust the volume
division for the left and right channel.
The zero position corresponds to an
equal level on both channels.

Adjusts the master volume.
T19 
Sets an automatic loop with the adjus-
ted loop length (-T15-), without having
to manually set the ending point.

Manually sets the starting point of a loop.
Simultaneously a cue point will be set.
T20 
Jumps to the last set loop and reacti-
vates it.

Manually sets the ending point of a loop.
Now the deck is in a loop mode, the selected
sequence is permanentely repeated.
Pressing the button again will end the loop
mode.
T21 
Carries out a beat jump against oppo-
sed to the playback direction.

Shifts the grid that Traktor puts over the bass
line a step to the left.
T22 
Carries out a beat jump in the playback
direction.

Shifts the grid that Traktor puts over the bass
line a step to the right.
T23 
Selects the desired hot cue bank. If
„1-4“ is pressed, the hot cue points 1-4
can be controlled in Traktor. Shortly
pressing „5-8“ facilitates the control of
hot cues 5-8 via the Hot Cue Buttons
-T24-.
T24 
Herewith it is possible to control the 8
hot cues of a track in Traktor. Depen-
ding on which bank is currently active
hot cues 1-4 and 5-8 respectively can
be controlled.
If a hot cue is not occupied (no LED
feedback), this hot cue will be assigned
to the current track position by pres-
sing one of the pads.
T25 
If this element is pressed, the current
track position is saved on a free hot
cue.
T26 
While this button is being pressed and
held the saved hot cue points can be
deleted by pressing the corresponding
hot cue pads -T24-. The LED of the
corresponding pad will go out.
Afterwards release the Delete Button in
order to leave delete mode.