User Guide
Performance Pads
• Hot Cue Mode: When pressing pads 1-8 you can add up to 8 Cue
Points. Holding SHIFT and pressing buttons 1-8 will delete the Cue Points.
Press Hot Cue mode twice to enable Cue Loop mode. Press pads 1-8 will
play a Loop Roll from the Cue point position.
• Loop Roll Mode: When pressing buttons 1-8 you can activate a loop
roll. The loop length is determined by the Auto Loop Range currently
selected in the Loop section of the software, which you can change
using the PARAMETER + and - buttons. Press Roll twice to enable
Saved Loops mode. Pads 1-8 will trigger saved loops.
• Sampler Mode: Buttons 1-6 Trigger Samples loaded in your Sample
Banks. Use PARAMETER1 Left/Right buttons to cycle through Sample
Banks. Press the Sampler mode button twice to enable Pitch Play mode.
Press and hold the performance pad for 3 seconds to access Sampler
Velocity mode. When enabled the Sampler sample slot volume will now
be velocity sensitive when played using the performance pads.
• Slicer Mode: A specied range (or domain) is divided into eight equal
sections, and these eight sliced sections are assigned to the respective
performance pads. Pressing SLICER once for the rst mode, is a shifting
Slicer Domain. Pressing SLICER twice, for the second mode is a xed
Slicer Domain or “loop”. Use PARAMETER1 to set the quantization for
the slicer function. The quantization can be set in four ways: 1/8, 1/4,
1/2 and 1. Hold SHIFT + PARAMETER1 to set the domain. The domain
can be set to one of six settings: 2 beats, 4 beats, 8 beats, 16 beats,
32 beats or 64 beats.
The Reloop MIXON4 RGB performance pads have 9 different modes you can
select. The rst four modes are; Hot Cue, Loop Roll, Sampler and Slicer.
The second four modes (Cue Loop, Saved Loop, Pitch Play, and Slicer Loop)
are activated by pressing the performance pad mode buttons a second time.
Sampler Velocity mode can can activated by pressing and holding Sampler.
Pressing and holding Hot Cue will enable Quantize.