User Manual

Table Of Contents
31


If a problem should arise while using Reloop Terminal Mix 4 the following chart is the rst drop-in center:
  
The device does not receive any
power when turning it on via the On/
Off Button -B44-.
USB cable is not connected correctly. Check whether the USB cable is connected to a USB
port of your computer and the USB port of Terminal
Mix 4 -B45-.
The controller‘s LEDs are only wea-
kly lit and the device does not react.
The power supply is not sufcient. Please install the ASIO driver again. To do so please
also read the paragraph “ASIO Driver Installation” in
the chapter “Computer conguration”.
Not all outputs of the integrated
audio interface can be selected in
the DJ software.
The ASIO driver is not installed correctly. Bitte installieren Sie den ASIO-Treiber erneut. Lesen
Sie dazu bitte den Abschnitt „ASIO Treiber-Installati-
on“ des Kapitels „Computer-Konguration“.
The audio interface‘s sound is
distorted.
- The ASIO driver is not being used.
- The performance settings do not corres-
pond to the computer‘s capacity.
- Please make sure that the ASIO driver is installed
and is also being used. To do so please read the
paragraph “ASIO Driver Installation” in the chapter
“Computer Conguration”.
- It is also possible that in the ASIO driver‘s settings
the available computer capacity has to be re-
congured. To do so open the Reloop ASIO settings
and increase the “ASIO Buffer”.
There is a problem that is not listed
here.
Various causes. Visit the website www.reloopdj.com/forum to get
support for your Reloop products.