Owner`s manual

1. Antenna Socket

The 50-ohm coaxial feed line to the antenna must be connected here, using a Type-

M (PL-259) connector.

2. 13.8V DC Input Connector

The supplied DC power cable must be connected to this connector. Use only the

supplied fused cable.

3. External Speaker Jack

An external loudspeaker may be connected to this 3.5mm audio jack.

Caution: Do not connect either wire of this line to ground, and be certain that the

speaker is capable of handling the audio output (4W) from the radio.

4. D-Sub 15-Pin Accessory Port Connector

External TX audio line input, PTT (Push To Talk), and external RX audio Line output

signals may be obtained from this connector for use with accessories such as data

transmission.

LCD Icons and Indicators

REAR PANEL

8-Charactor Alpha-

Numeric Display

Transmission

in progress

(follows red

BUSY/TX indicator)

Indicate strength

of radio wave

Transmission power level

Monitor in progress Scan Enabled

Talk-Around Enabled

Key-Lock Enabled

3 4