Specifications

RMU800A SERVICE MANUAL
－ 23 －
Note: Only the same models can be cloned together.
Wireless Clone Mode
(1) Turn on the source radio while holding down [PF5] simultaneously, the radio enters Clone Mode with
“CLONE” on the LCD, or enters User Mode if Clone Mode is set OFF by your dealer.
(2) Press [PF1], the radio enters Wireless Clone Mode with “WIRELESS” on the LCD. The initial
frequency that matches the destination is displayed in 2 seconds. Turn the Selector Knob to choose
desired frequency. Press [PF1] again to return to Clone Mode.
(3) Press [PF2] to toggle between Dealer Clone and Factory Clone Mode. “Dealer Clone” or “Factory
Clone” appears on the display when the corresponding mode is selected. The radio returns to
original display mode in 5 seconds.
Unlike Factory Clone Mode, adjustment settings and embedded messages are not covered in
Dealer Clone Mode.
Dealer Clone Mode is the default mode.
(4) Repeat step1-2 to operate the target radio, the frequency is set the same as that of source radio.
(5) Press [PF6] to start wireless cloning. The LED of source radio glows red and that of target radio
glows green during cloning. “CLONE 00%” is displayed on both source and target radios. “BUSY”
mark also appears on the target radio. The leftmost 2 digits (00) on the LCD show the data transfer
rate and count upwards in increments of 1 as data transmission/reception proceeds.
(6) (6) When data transmission is completed, “END” appears on the source radio and red LED goes
out. Press [PF1], the source radio displays the frequency, repeat the above steps to continue
wireless cloning. The target radio reset when all data is received.
Note: Clone Mode can be enabled/disabled by your dealer. Wired cloning is accessible only when Clone
Mode is enabled. Refer to “Clone Mode” in “Mode Information” of “Dealer Mode”.