User's Manual

36
KNG User’s Manual
Either priority channel can be programmed as a fixed channel, tied
to the Channel Selector knob, or programmed OFF. If the radio is
programmed to transmit on PR1, transmissions will occur on the first
priority channel when operating in Priority Scan Mode.
Priority Scan can be used in combination with Code Guard. If a
message is received on a priority channel, the radio receiver locks on
to the priority channel and checks to see if the proper Channel Guard
value is present. If the signal contains the proper Channel Guard value,
the radio receives the message. Otherwise, the radio will re-check the
channel every 4 seconds, until the activity on the channel ceases.
If enabled the user can use the keypad to change the priority channels.
The Priority Channel selection can be programmed to a programmed
button or as a menu item.
To select a new Priority Channel:
Button Operation
Pri Chans
Priority 1
Priority 2
ESC ▲ ▼ ENT
Glob Pr1 Zone
→
Zone 1
Zone 2
ESC ▲ ▼ ENT
Glob Pr1 Chan
→
Channel 1
Channel 2
ESC ▲ ▼ ENT
Priority 1
Use Global
Use Per Zone
ESC ▲ ▼ ENT
Global Pri 1
Pri 1 Zone
Pri 1 Chan
ESC ▲ ▼ ENT
Press the programmed button.
PRI
Use the up/down buttons to select 'Pri. 1.
Channels'.
Press 'ENT'.2.
Use the up/down buttons or to select the 3.
desired priority channel.
Press 'ENT'.4.
Select 'Use Global' to assign a radio 5.
wide priority channel or 'Use Per Zone' to
assign a zone priority channel.
Use Global
6a. Select "Priority 1 Zone"
6b. Use the up/down buttons to select
the zone.
6c. Press 'ENT' to set the zone.
6d. Select "Priority 1 Channe"l
6e. Use the up/down buttons to select
the channel.
6f. Press 'ENT' to set.