User's Manual

34
KNG User’s Manual
Once the signal ends, the radio continues to monitor the channel for
the preset scan delay time before it resumes scanning.
Toggle switch operation
On - Slide the programmed switch toward the front of the radio.
Off - Slide the switch up toward the channel select switch.
Zone Select
Channel Scan
PRI Scan
ESC ▲ ▼ ENT
TXD
Channel Scan
→
Off
On
ESC ▲ ▼ ENT
Button Operation
On - Press the programmed button.
SCAN
Off - Press the button again. SCAN
Menu Operation
Press the assigned Menu button.1.
Use the up/down buttons to select 2.
'Scan'.
Press the ENT button.3.
Use the up/down buttons to select 'On' 4.
of 'Off'.
Press the 'ENT' button to set the 5.
selection.
Hold the 'ESC' button to return to 6.
normal operation.
Scanning Code Guarded Channels
When a signal is detected, scanning stops while the radio checks for
the proper Code Guard value. If the signal contains the proper Code
Guard value, the radio receives the message. Otherwise, the radio
resumes scanning immediately.
Nuisance Channel Delete
If your radio is programmed for Nuisance Channel Delete and
Channel Scan is assigned to a top toggle switch, a Nuisance
Channel can be temporarily removed from the Scan List by sliding
up and then back down. Turn off Scan for at least five seconds or
cycle radio power to revert to programmed scan list.
Transmitting with Scan On
The radio transmits on the channel selected by the Channel Selector
knob unless Talkback Scan is enabled or “Transmit on Priority 1” is
enabled (see Priority Scan).
When the PTT switch is released, the radio continues to monitor the