User's Manual

28
KNG User’s Manual
Press the enter key to begin the key transfer.
When the key information has been sent the radio will momentarily
display “Key Transfer Successful”.
Key
Transfer
Successful
CANCEL OK
If the radio is not programmed for Tactical OTAR
operation or is on a non-OTAR channel the
display will read “Non-Tact., OTAR Channel”.
Should the key transfer fail for any other reason
a failure message with a two digit error code will
be displayed.
(See table below.)
Tactical OTAR Error Code Table
Code Description
01
General Failure
02
DTEK Not Found or Not AES
04
MTEK Not Found or Not AES
F0
General Failure during Key Wrap
F1
Key Not Found for Key Wrap
F4
Key to Wrap Key is Not identified as a KEK
Receiving Keys
OTAR Key Target Radio
Select the channel designated as the OTAR channel to receive the rekey
information.
Key 5
Received
Upon successful key transfer the radio will show
the received key’s programmed label and “Key
Received”. The key received message remains
displayed until radio power is cycled.
The radio will operate normally even while the
message is displayed.
If the key transfer is unsuccessful no message will be displayed.