User's Manual

22
KNG User’s Manual
DTMF/ANI Operation
The KNG portable radio can be programmed, on a zone-by-zone basis,
to send DTMF tones manually via the keypad and/or send a DTMF ID
automatically (ANI).
Ch 1
KNG - P25
171.58500 MHz
A B C D
TXA
Ch 1
KNG - P25
171.58500 MHz
TXA
A B C ANI
ANI Only - If the zone is programmed to for 'ANI
Only' the programmed ANI ID number will be
sent with each PTT.
DTMF Only - If the zone is programmed to for
'DTMF Only' the alphanumeric keys are used to
transmit DTMF tones while holding the PTT. The
square, up/down and diamond buttons are used
to send A, B, C and D characters.
ANI and DTMF - If the zone is programmed for 'Both',
the ANI is transmitted when the square button is
pushed during transmit. DTMF tones are sent by
pressing the alphanumeric keys during transmit.
NOTE: The "D" DTMF tone is only available after
the ANI has been sent.
Encryption Operation
The radio may optionally be configured for Secure communication on
channels operating in Digital Mode. No encryption is available for analog
channels.
Required Setup
Radios that have the DES/AES factory option for encryption must
have encryption keys loaded with an APCO Project 25 compatible
key fill device such as the Motorola KVL 3000 Plus, using a BK Radio
keyloader cable. The radio can hold up to 32 AES and/or DES keys.
After loading keys in the radio, the KNG PC programming software
must be used to configure the radio’s key table and to assign default
transmit keys to each channel.
Radios that have the OTAR factory option support Over-the-Air
Rekeying of encryption keys (OTAR). The KNG PC programming