User's Manual

64
KNG User’s Manual
65
RELM/BK Radio
RADIO CLONING
Any “Master” radio (a KNG with the desired radio frequencies and
settings) is capable of transferring its program to another KNG of the
same frequency range. The radio receiving the program is referred to as
the “target” The KAA0710 cloning cable will be required in the following
procedure.
Zone Cloning
When 'Zone' is selected from the cloning menu, information from the
selected zone is sent to the corresponding zone of the radio being
cloned.
Clone zoned information includes:
Channel and Zone Labels
Frequencies
Operating Modes
Code Guards (CG)
Network Access Codes (NAC)
Squelch Operation
Talk Groups
Scan List
Bandwidth
Low Power Selection
ANI Settings
Zone Priority Settings
Zone Scan List Selection
NOTE: Some groups may be blocked by PC programming to prevent
them from being overwritten. Only unlocked groups will accept
incoming clones.
Entire Radio Cloning
When 'Entire Radio' is selected from the cloning menu, information
from the all zones is sent to the corresponding zones of the radio
being cloned.
NOTE: Radios programmed with any zones blocked from receiving
cloning information will not accept an 'Entire Radio' clone.
Entire Radio cloning transfers all radio information except the following:
Radio Serial Number
P25 Identifi cation Number
Encryption Keys
Passwords
Operation
Cloning...
Cloning
Successful
Cloning Failed
Zone X is
uncloneable
Cloning
Zone
Entire Radio
Wait for Incoming
ESC ▲ ▼ ENTER
Awaiting
Incoming
Clone...
Target Radio
Cloning
 Zone
Entire Radio
Wait for Incoming
ESC ▲ ▼ ENTER

Zone Select
Zone 1
Zone 2
Zone 3
ESC ▲ ▼ ENTER
3
2
1
Master Radio
Make sure the battery packs for both radios 1.
are charged.
Attach the cloning cable to the side 2.
connectors and power up radios.
Select 'Cloning' From the programmed menu 3.
on both the Master and Target radios.
On the Target radio select 'Waiting for 4.
Incoming Clone'
On the Master radio select the desired 5.
cloning function.
Select Zone Cloning•
Use the up/down arrows to select the zone
to be cloned or select the zone directly
using the number buttons.
Press 'ENTER' to begin cloning.
Select Entire Radio Cloning•
Cloning begins when the 'ENTER' button
is pressed.
While sending or receiving information 'Cloning...'
will be shown on both the Master and Target
radio displays. After successful information
is transferred 'Cloning Successful' is briefl y
displayed before reverting to cloning standby
mode. Cycle the Target radio power before
operating.
If the cloning procedure fails a communications
failure will be shown on the Master radio's
display. Press 'ESC' to return to the cloning
menu.
If the target zone is blocked from accepting
a clone, or when any zone is blocked during
an attempt to do an 'Entire Radio' clone, the
'Cloning Failed' message is displayed.