User's Manual

48
KNG User’s Manual
49
RELM/BK Radio
Receive Mode

Rx Mode
Analog
Digital
Mixed
ESC ▲ ▼ ENTER
1. Select 'Rx Mode' from the menu.
2. Use the up/down buttons to select the
desired receive mode.
3. Press the 'ENTER' button to save the
setting and return to the programming list.
Receive Code Guard

Rx Guard
Off
Tone ->
Digital->
ESC ▲ ▼ ENTER
Rx Guard
Off
Tone -> 100.0Hz
Digital ->
ESC ▲ ▼ ENTER
Rx Guard
Off
Tone ->
Digital -> D131
ESC ▲ ▼ ENTER
NOTE: Code Guards are available only on
channels programmed for analog or mixed
mode operation.
Select 'Rx Guard' from the menu.1.
The arrow indicates the currently programmed
Code Guard for analog signals.
Use the up/down buttons to select the 2.
desired Code Guard type.
(Off = carrier squelch)
Use the keypad to program the desired 3.
Code Guard. (See below)
Programming a CTCSS Tone
Guard Tone
100.0 Hz
ESC CLEAR EDIT
Guard Tone
000.0 Hz
ESC BACK NEXT ENTER
Select 'Tone' from the menu.1.
Press the 'CLEAR' button to clear the 2.
currently programmed tone or press the or
'EDIT' button to edit the tone.
To enter CTCSS tones use the keypad to 3.
enter the tone in Hertz. (67.0 - 255 Hz)
Press the 'ENTER' button to set the tone 4.
and return to the programming menu.
Programming a CDCSS Tone
Guard Tone
D121
ESC CLEAR EDIT INV
Guard Tone
121
ESC BACK NEXT ENTER
Guard Tone
D121-
ESC CLEAR EDIT INV
Inverted DCS Tone
Select 'Digital' from the menu.1.
Press the 'CLEAR' button to clear the 2.
currently programmed code guard or press the
or 'EDIT' button to edit the guard.
To enter CDCSS tones use the keypad 3.
to enter a three digit code guard. (000 - 999)
Press the 'ENTER' button to set the 4.
tone and return to the programmable menu.
NOTE: If an inverted CDCSS is desired, press
the 'INV' button prior to editing the code guard.
Receive Network Access Code
Guard Tone
100.0 Hz
ESC CLEAR EDIT
Guard Tone
000.0 Hz
ESC BACK NEXT ENTER
Select 'Rx NAC' from the menu.1.
Press the 'CLEAR' button to clear the 2.
currently programmed NAC or press the or
'EDIT' button to edit the NAC.
Use the keypad to select the fi rst digit.3.
Press the 'NXT' button to move to the next 4.
character.
NACs are programmed as three digit
hexadecimal numbers. (000 - FFF)
Press the 'ENTER' button to set the tone 5.
and return to the programming menu.
Squelch Mode

Squelch Mode
Normal
Selective
ESC ▲ ▼ ENTER
Select 'Squelch Mode' from the menu. 1.
Use the up/down arrows to select Normal 2.
or Selective. (Selective squelch is required for
Individual Calls and use of Talkgroup IDs.)
Press the 'ENTER' button to set the tone 3.
and return to the programming menu.