User's Manual

26
KNG User’s Manual
27
RELM/BK Radio
Menu Operation:
Select 'TX Power' from the programmed menu.1.
Use the up/down buttons to select 'High' or 'Low'.2.
Press the 'ENTER' button to set the selection.3.
Hold the 'ESC' button to return to normal operation.4.
Version (VER)
The 'Version' functions provides information about the radio's
fi rmware. Information on current fi rmware revisions may be found at
www.relm.com. or from the RELM Wireless Service Department.
Zone Select (ZON)
Ch 1
KNG - P25
Zone Label
MON T/A MENU TXD
TXD
KNG - P25
Zn 12 : Ch 15
MON T/A MENU TXD
TXD
The 512 channels available in the KNG can
be divided into multiple operating zones.
Switching between zones is accomplished
via a programmed button or menu item.
Optionally, zone labels or numbers can be
displayed on the LCD. (See Alphanumeric
Label Options.)
Channel Scan
Zone Select
PRI Scan
ESC ▲ ▼ ENTER
TXD
2
1
3

Zone Select
ZONE 1
ZONE 2
ZONE 3
ESC ▲ ▼ ENTER
3
2
1
Operation:
Press the button programmed for 'Zone 1.
Select' or select 'Zone Select' form the
programmed menu.
Use the up/down buttons to select the 2.
desired zone or use the number buttons to
enter the desired zone number.
Press 'ENTER' to set the zone.3.
Hold the 'ESC' button to return to normal 4.
operation.
Scan Operation Options
Channel Scan (SCAN)
Ch 1
KNG - P25
171.58500 MHz
MON T/A MENU TXD
Ch 1
KNG - P25
171.58500 MHz
MON T/A MENU TXD
RXD SCN
SCN
The display indicates scan operation by
fl ashing SCAN.
Scan operates only while the radio is not
transmitting. The radio checks for signals on
channels in the preset Scan List, as well as
the channel selected by the Channel Selector
knob.
When a signal is detected, scanning stops
and the message is received. The received
channel is shown in place of the selected channel.
Once the signal ends, the radio continues to monitor the channel for
the preset scan delay time before it resumes scanning.
Toggle switch operation:
On - Slide the programmed switch toward the front of the radio.
Off - Slide the switch up toward the channel select switch.
Zone Select
Channel Scan
PRI Scan
ESC ▲ ▼ ENTER
TXD
Channel Scan

Off
On
ESC ▲ ▼ ENTER
2
1
3
Button Operation:
On - Press the programmed button.
SCAN
Off - Press the button again. SCAN
Menu Operation:
Select 'Scan' from the programmed 1.
menu.
Use the up/down buttons to select 'On' 2.
of 'Off'.
Press the 'ENTER' button to set the 3.
selection.
Hold the 'ESC' button to return to normal 4.
operation.
Scanning Code Guarded Channels
When a signal is detected, scanning stops while the radio checks for
the proper Channel Guard value. If the signal contains the proper
Channel Guard value, the radio receives the message. Otherwise, the
radio resumes scanning immediately.