User's Manual
Table Of Contents
- Front
- Contents
- Introduction
- FCC Requirements
- Radio Controls
- LCD Touch Screen
- Microphone Controls
- Function Selection
- Channel/Zone Selection Options
- Basic Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signalling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning
- Control Lockout [LCK]
- Keypad Programming
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Radio info
- Repeater Talkaround [T/A]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Keypad Programming
- Warranty
- 30 -
KNG Mobile Manual
Transmit
Press the 1. PTT (Push-To-Talk) switch on the microphone. The TX annunciator
appears on the display and the red Transmit indicator illuminates while the
PTT is pressed.
Talk in a normal voice with the microphone approximately one to two inches 2.
from your mouth.
Release the 3. PTT switch to stop transmitting.
If the TX annunciator does not appear and a tone is heard, you are on a 4.
receive-only channel or the channel is busy and Busy Channel Lockout is
enabled. Turn the Channel Selector knob to an authorized transmit channel or
wait until the channel is clear.
If the length of your transmission exceeds the preset Time-Out Timer setting, 5.
the transmitter automatically shuts off and a tone sounds. To continue the
transmission, release the PTT switch, then press it again and continue talking.
Contents