User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Information and Options
- Radio Controls
- LCD Touch Screen
- Microphone Controls
- Function Selection
- Channel/Zone Selection Options
- Basic Operation
- Trunking Channel Basic Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Scan Options
- Encryption Operation
- User Pick List Options
- Emergency Signaling
- Messaging Options
- Paging and Call Alert
- Other Functions & Options
- Backlight [LITE]
- Cloning
- Control Lockout [LOCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Home [HOME]
- Inhibit/Uninhibit [INH]/UINH]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [NUIS]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio Info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE]
- Keypad Programming Options
- 85 -
KNG Mobile Operation
Send Alert Tone [SNDT]
Conventional and Trunking Channels
When pressed and held, the radio will transmit a 781.3Hz tone for the programmed
duration. Duration can be set in the range from 0.5 to 5 seconds.
Send Signal [SEND]
Conventional Analog Channels
Activated by a long-press and is the 5-tone equivalent to emergency alarm. ANI
Mode needs to be set to ve-tone. Holding this button will send the ve-tone signal.
Squelch Adjust [SQL]
Conventional Analog and Mixed Mode Channels
Squelch Adjust is used to change the signal strength required for the radio's speaker
to unmute on a per channel basis.
Adjusting Squelch Level
Press the "SQL" button or select "Squelch Adjust" from the menu.
Select "Adjust Chan Squelch" form the menu.
Use the -/+ buttons to adjust the desired squelch level.
Press "ENTER" to set the level.