User's Manual

ManualsBrandsRELM WIRELESS CORP. - BK RADIO ManualsElectronicsMOBILE LAND MOBILE TRANSCEIVER

Table Of Contents

Introduction
FCC Requirements
Industry Canada Compliance
Information and Options
Radio Controls
LCD Touch Screen
- Status Indicators
- Channel Information Display Options
- Programmable Button and Menu Options
Microphone Controls
Function Selection
- Touch Screen Selection
- Navigation Wheel Selection
- Menu Screen Selection
Channel/Zone Selection Options
Basic Operation
Trunking Channel Basic Operation
Command Zone Operation
- Building a Command Zone [CHAN+]
- Editing a Command Zone [CHAN-]
Code Guard/NAC Operation
- Code Guard Receive
- Code Guard Transmit
- Analog Squelch Control
- APCO Project 25 Digital Squelch Control
Mixed Mode Operation
Scan Options
- Channel Scan [SCAN]
- Channel Scan List [SCN+]
- Talkback Scan
- Dual Mode Scan [DSCN]
- Dual Mode Scan List [DSED]
- Enhanced Scan [ESCN]
- Priority Scan/System Scan [PSCN]
- Priority Channel Select [PRI]
- Vote Scan
- Zone Scan [ZSCN]
- Zone Scan List [ZSC+]
Encryption Operation
- Required Setup
- Transmit Secure [SEC]
- Transmit Encryption Key Selection [KEY]
- Encryption Keyset Selection [KEYST]
- Rekey Request [RKEY]
- Keyset Viewing and Selecting [KSET]
- Zeroizing [ZERO]
User Pick List Options
- TX/RX CxCSS Picklist [TXCG] [RXCG]
- TX/RX Network Access Code Picklist [TNAC] [RNAC]
- Talk Group ID Picklist [TGID]
- Encryption Key Picklist [KEY]
- Keyset Picklist [KSET]
Emergency Signaling
Messaging Options
- Text Messaging [TXT]
- Short Message Update [MSG]
- User Status Messaging [STS]
Paging and Call Alert
- Conventional Two-Tone/DTMF/MDC1200 Paging [MUTE]
- Call Alert Paging [ALRT]
- Radio Check [RCHK]
Other Functions & Options
- Backlight [LITE]
- Cloning
- Control Lockout [LOCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Home [HOME]
- Inhibit/Uninhibit [INH]/UINH]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [NUIS]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio Info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE]
Keypad Programming Options
- Entering Programming Mode
- Keypad Programming
- Call List Programming
- Code Guard Picklist Programming
- NAC Picklist Programming
- Talkgroup ID Picklist Programming

- 8 -

KNG Mobile Operation

Industry Canada Compliance

This device complies with Industry Canada’s license-exempt RSSs. Operation is

subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux

appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions

suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de

l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d'en compromettre le fonctionnement.

WARNING:

Under Industry Canada regulations, this radio transmitter may only operate using

an antenna of a type and maximum (or lesser) gain approved for the transmitter by

Industry Canada. To reduce potential radio interference to other users, the antenna

type and its gain should be so chosen that the equivalent isotropically radiated power

(e.i.r.p.) is not more than that necessary for successful communication.

Conformément à la réglementation d'Industrie Canada, le présent émetteur radio

peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur)