User's Manual
Table Of Contents
- Introduction
- FCC Requirements
- Industry Canada Compliance
- Information and Options
- Radio Controls
- LCD Touch Screen
- Microphone Controls
- Function Selection
- Channel/Zone Selection Options
- Basic Operation
- Trunking Channel Basic Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Scan Options
- Encryption Operation
- User Pick List Options
- Emergency Signaling
- Messaging Options
- Paging and Call Alert
- Other Functions & Options
- Backlight [LITE]
- Cloning
- Control Lockout [LOCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Home [HOME]
- Inhibit/Uninhibit [INH]/UINH]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [NUIS]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio Info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- Transmit Digital [TXD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE]
- Keypad Programming Options
- 93 -
KNG Mobile Operation
Displayed Information
Information displayed on the three programmable display lines can be edited by
selecting Top Line, Middle Line or Bottom Line from the Global menu.
Use the up/down buttons to select the desired displayed information for each line.
Alternating Display Information
All three display lines can be programmed to alternate displayed information.
Alternating displayed information on the three programmable display lines can be
edited by selecting Top Line Alt, Middle Line Alt or Bottom Line Alt from the Global
menu.
User Password
The User Password is used only for entering the keypad programming mode. The
Administrator and Startup Passwords cannot be changed via the keypad.
Select "CLEAR" to reset the password to all zeros. Use the microphone keypad to
enter a new six-digit password.
To edit individual digits select "EDIT". Use "PREV" and "NEXT" to highlight the
digit to change. Use the microphone keypad to enter a new digit.
Select "ENTER" to set the password and return to the previous step.