User Manual

Installation and Programming GMH Series VHF Radio
Page 2-6 BK RADIO
2.2.2.2 Transmitter Time Out Timer
After the ID number is set, the display annunciator
will indicate
PRG TX
. This is the duration of the
transmitter Time Out Timer.
0 SEC
means the Time
Out Timer is disabled.
Press the
[PRI]
key to increase the Time Out Timer
duration by 15 seconds, with a maximum of 225
seconds (3 minutes, 45 seconds). Press the
[PRI]
key again to change the duration from 225 seconds
to zero.
Press the
[CLR]
key to set the Time Out Timer
duration to zero.
Press the
[ENT]
key to store the changed setting
and advance to the next section.
Press the
[FCN]
key to advance to the next section if
no change is needed.
2.2.2.3 Scan Delay Time
After the Time Out Timer is set, the upper display
will indicate
PRG SCN
. This is the scan delay time in
seconds.
Press the
[PRI]
key to increase the scan delay time
by .5 seconds, up to 7.5 seconds. Press the [PRI]
key again to change the time from 7.5 seconds to 0.
Press the
[CLR]
key to reset the scan delay time to
0.
Press the
[ENT]
key to store the changed setting
and advance to the next section.
Press the
[FCN]
key to advance to the next section if
no change is needed.
2.2.3 Channel 0 Group One Functions
After the scan delay time is set the display will show
PRG 1-12345
. This is a group of five individual
functions that can be enabled or disabled.
When a function is enabled, the corresponding
number in the display will flash. When the function is
disabled the number is steady. If you wish to
change the function from enable to disable or vice
versa, press the number key corresponding to that
function.
EXAMPLE: If function 4 (Priority Key Lockout) is disabled,
the 4 in the display will not be flashing. If the
[4]
key
is pressed, the 4 in the display will f'lash, signifying
that Priority Key Lockout is enabled. A subsequent
press of the
[4]
key wiIl disable Priority Key Lockout