User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
50
BK Radio
Priority Delay
Your dealer can set the priority delay time for
0 to 5 seconds in 0.5-second increments. This
time delay is the time from when you lose a
carrier for the priority channel and the time
the radio stays tuned to the receive frequency
of the priority channel. This is also the time
you have to transmit on the transmit
frequency of the priority channel.
Priority Receiving
Priority channel receive sampling only
occurs while the radio is not transmitting.
With priority mode enabled, the radio
samples either the programmed preset
priority channel (modes B or C), the
priority channel that you selected (modes
D or E), or the position of the channel
knob (mode A) (See Table 6).
Priority During Scan-All-Groups Scanning
The priority channel that is sampled and all
priority mode transmitting occurs within the
group the radio was in when Scan All Groups
scanning was initiated.
Table 6 summarizes channel selection,
whether scanning is in manual mode, whether
the talkback scan feature is enabled, and
whether a carrier is present at the time you
press the PTT switch. This information is
only for channel selection. Other settings,
such as busy-channel lockout during active
carriers, will still determine whether actual
transmission is possible.