User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
44
BK Radio
When you are scanning with both scan all
and priority enabled, the priority channel
you are sampling or transmitting on will
occur within the group that the radio was
in when you started the scan-all-groups
scanning.
When you change the radio from manual to
scan mode with scan all enabled and then
later you switch back from scan to manual
mode, the radio returns back to the group
it was in when you started scan mode.
Change the Scan List
Your dealer can program your radio to
give you the option of changing the scan
list channels yourself.
Scanning Options
Advanced Aurora radio models offer
several scanning options:
Scan Delay
The Aurora radio has a scan-delay time
parameter from 0 to 5 seconds in 0.5-
second increments. Your dealer can
program this time parameter on a per radio
basis.
The scan-delay time starts when the person
you are listening to stops talking. The
length of time your radio stays on that
scanned channel gives you time to transmit
or continue receiving on that channel
before the radio starts scanning again.
P000.0000