User's Manual
Table Of Contents
- WELCOME
- INTRODUCTION
- Optional Accessories
- External Speaker/Microphone
- External VOX Headset
- Battery Packs
- FCC REQUIREMENTS
- SAFETY PRECAUTIONS
- Dealer Programmable Options
- Before Using Your Radio
- Battery Installation and Removal
- Antenna Installation and Removal
- Radio Views
- Aurora Radio Controls
- Front View
- Display
- Backlight
- Keypad
- Speaker
- Top View
- Status Indicator
- On/Off Volume Knob
- Squelch Knob
- Programmable Three-Position Switch
- Emergency Button
- Channel Selector Knob
- Side Views
- PTT Switch
- Programmable Softkey Buttons
- Options Connector
- Basic Operation 23
- TRANSMIT
- Code Guard Operation
- Code Guard Receive
- Code Guard Transmit
- Scan Operation
- Talkback Scan
- Scan All Groups
- Change the Scan List
- Scanning Options
- Scan Delay
- Talk Around
- Scan in Tone Mode
- Scan in Monitor Mode
- Transmit on Priority Channel
- Channel Scan Delete/Add
- Priority Scan
- Priority Scan with Code Guard
- Priority Modes
- Priority Delay
- Priority Receiving
- Priority During Scan-All-Groups Scanning
- Receive Mode
- Groups
- Display Modes
- Tuning Range
- Frequency Display Mode
- Alpha Display Mode
- Channel Display Mode
- Selective Calling
- Receiving a Call
- Sending a Call
- Radio Check
- DTMF Dialing
- Originating a Call
- Frequently Called Numbers and Call Paging
- Radio Paging
- Flex Mode
- Keypad and Channel Selector Lock
- Busy Channel Lockout
- Battery Power
- Battery Saver
- Radio Power-Up
- Error Messages
- Stun
- Aurora Programmed Switch Settings
- Troubleshooting Guide
- Service
- _
- Specifications
- Definitions and Acronyms
40
BK Radio
OPERATING MODES
MANUAL MODE
The Aurora radio can operate in manual
mode, which ties the receive and transmit
frequencies to the channel you select with
the channel selection knob (within the
currently selected channel group).
For advanced model radios, you can select
manual mode from the function menu if
manual/scan or talk around is not assigned
to the three-position switch.
For advanced radios in tone mode [ ],
your radio displays the receive and
transmit frequencies that indicate the
reassigned Code Guard. You can see the
number of the reassigned channel in the
right-most part of the radio display.
Receive and transmit frequencies also
indicate the assigned radio paging code
(audible signals) by lighting the paging icon
[ ] in the display when the radio is
tuned to that frequency.
When the radio is in monitor mode, the
paging code icon is not lit.
Channel
Selector
Knob
000.0000
000.0000
000.0000
12
Reassigned
channel number