User Manual

ManualsBrandsRelief Pak ManualsHot & Cold PacksHotSpot® Neck Moist Heat Pack, 9"L x 24"W

MOIST

HEAT

PACKS

and COVERS

● moist heat pack is a simple and effective method of applying localized heat

●gives at least 30 minutes of therapeutic moist heat

● apply pack with a Relief Pak

cover or a heavy towel

●when treatment is complete pack can be stored in a plastic bag in freezer

● terry hot pack cover allows therapeutic moist heat to penetrate without burn-

ing the skin

● covers are filled with foam or additional terry

● hook and loop fasteners keep moist heat packs in place in cover

●covers are washable (see instructions page 2-3)

Fabrication Enterprises, Inc.

PO Box 1500, White Plains, New York 10602 (USA) www.Fab-

Ent.com

INSTRUCTIONS

Manufacturer and Master Distributor of

Physical Therapy and Rehabilitation Products

ver 10/10

Summary of content (4 pages)

PAGE 1
INSTRUCTIONS MOIST HEAT PACKS and COVERS ● moist heat pack is a simple and effective method of applying localized heat ● gives at least 30 minutes of therapeutic moist heat ● apply pack with a Relief Pak® cover or a heavy towel ● when treatment is complete pack can be stored in a plastic bag in freezer ● terry hot pack cover allows therapeutic moist heat to penetrate without burning the skin ● covers are filled with foam or additional terry ● hook and loop fasteners keep moist heat packs in place in cover
PAGE 2
Relief Pak® moist heat pack and covers pack Style (pack size) standard - 10x12” / 25x30cm standard with pocket neck - 7x24” / 18x60cm 11-1310 oversize - 15x24” / 38x61cm oversize with pocket half size (5x12”) 11-1312 circular - 10” / 25cm diameter hand - 7x13” / 13x30cm dual hand 11-1205 11-1321 spine small - 10x18” / 25x46cm spine large - 10x24” / 25x61cm knee-shoulder - 10x20”/25x51cm 11-1314 11-1315 11-1316 circular 11-1311 11-1313 terry covers foam-filled 11-1360 11-1364 11-1361 terry-fill
PAGE 3
Heat your moist heat pack 1. Hold pack by corner loops and gently shake. This distributes the filler and permits it to swell (absorb water) evenly. 2. Place pack in heating unit (for home, use a large pot or pan). 3. Fill heating unit with enough water to keep pack completely immersed. 4. Let pack soak for at least 2 hours. Pack will become completely swollen with water. This long soaking procedure is necessary only with a new pack. After initial use, pack can be prepared by soaking for 15-20 minutes. 5a.
PAGE 4
2. Remove pack from heating unit with tongs by gently lifting loop tab. 3. Place pack on the left side of the cover. 4. Fold cover over the pack. Make sure the hook/loop fasteners are aligned. 5. Press hook/loop fastener together to secure the pack. Note: Oversize pack can be covered by 1 oversize cover or 2 standard covers (1st cover hook/loop up, pack in middle, 2nd cover hook/loop down). ► Care for moist heat pack cover Covers can be laundered in washing machine and dryer. Wash separately, no bleach.