Instruction manual

10
TROUBLESHOOTING
%POPUPQFSBUFUIFTUFBNDMFBOFSXJUIBEBNBHFEDPSEQMVHPSJGUIFTUFBNDMFBOFS
IBTCFFOESPQQFEPSEBNBHFE5PBWPJESJTLPGFMFDUSJDTIPDLEPOPUEJTBTTFNCMF
or attempt to repair the unit on your own. Return the unit to Reliable Corporation
TFFXBSSBOUZGPSFYBNJOBUJPOSFQBJSPSSFQMBDFNFOU
PROBLEM
No steam is released through
the steam fittings.
%SPQTPGXBUFSMFBLGSPNUIF
attachments.
%JSUZXBUFSJTDPNJOHPVU
Not enough steam pressure.
Pump is not stopping.
REMEDY
1. Turn steam unit onto the
2nd position.
2. Put required amount of
XBUFSJOUPUBOL
3. Plug unit into outlet.
 8BJUGPSMJHIUUPUVSOPO
 8BJUGPSMJHIUUPUVSOPO
 -FUXBUFSSVOUISPVHITZT-
tem until steam comes out.
 'PMMPXDMFBOJOHJOTUSVDUJPOT
JOCPPL
1. Turn the dial until the de-
sired pressure is reached.
1. Press the switch on the
steam handle. Hold for a few
seconds until the pump is
primed.
POSSIBLE CAUSES
1. Steam unit is not turned on.
 8BUFSUBOLJTFNQUZ
 6OJUJTOPUQMVHHFEJO
 (FOFSBUPSJTOPUGVMMZ
heated.
 6OJUJTOPUGVMMZIFBUFE
2. Condensation was created
from non-use.
1. Scale may have built up.
1. The dial on the handle may
be set too low.
"OBJSCVCCMFNBZCFJO
the pump.