Instruction manual
27
PROBLEM
Poor suction
Anomalous noise of the motor 
The machine is at pressure but 
it does not release steam
Extension wands or 
accessories come loose easily
Extension wands or 
accessories are hard to fit
The red light indicating 
that the tank is running out of 
water, comes on 
The red light indicating 
that the tank is running out of 
water, comes on
POSSIBLE CAUSE
t 5IFBJSmMUFSJTEJSUZ
t 5IFSVCCFSTDSBQFSTPGUIF
cleaning brush have not 
been fitted correctly
t -PXTVDUJPOQPXFSPG 
the machine
t 5IFnFYJCMFIPTFJT 
clogged/kinked
t 5IFXBUFSESBJOIPTF 
is clogged
t 5IFMFWFMPGDMFBOXBUFSJOUIF
tank is too high (above the 
white mark inside the tank) 
t 5IFXBUFSJOUIFEVTU
collecting tank is at max level
t 5IFTUFBNSFHVMBUPSLOPC 
is closed 
t 5IFMPDLJOHMFWFSJTOPUMPDLFE
t 5IFDPOOFDUJOHHBTLFUT
produce friction 
t 5IFMPDLJOHMFWFSJTOPUJOUIF
central position
t 5IFXBUFSSFTFSWFIBT 
been used
t 5IFXBUFSSFTFSWFIBT 
been used 
SOLUTION
Clean the filter
Check they have been fitted
Operate button 10 (fig. 12) 
on the handle and increase 
the suction power
Disconnect the hose from the 
machine and eliminate any dirt
Eliminate any impurities from 
the drain hose (fig. 29)
Empty any water in excess 
of to the correct level
Drain water off the dust 
collecting tank
Turn regulator 41 
(fig. 11) anticlockwise
Shift the lever to 
 position 1 (fig. 5)
Lubricate the gaskets 
with some oil
Turn the lever to the 
central position
Fill the tank with water and 
wait some 30 minutes. 
If the light does not go off, 
address to the Technical 
Service Centre.
Fill with water
POSSIBLE PROBLEMS, CAUSES AND SOLUTIONS
MAINTENANCE










