Instruction manual

06
10. Itissafetoleavewaterinthepressuretankwhenthesteamcleanerisnot
inuse.Ifitisforanextendedperiodoftime(months)thenitisbesttoush
outtheremainingwater.Todoso,followthewaterremovalinstructions
as outlined in the maintenance of the boiler section.
THIS MODEL IS PROVIDED WITH THE
FOLLOWING FEATURES
RED CONTROL LIGHT (4)
Aredwarninglightsignalsthatthewaterinthetankhasbeenemptied.Abuzzerwill
soundincaseyoudidnotseetheredlight.Acontinuoushummingsoundfromthe
pumpcomesbeforethis.Atthispointswitchoffthesteamcleanerbyturningitto
position“0,”llthetankwithwaterandswitchbackon.
STEAM REGULATION (ON HANDLE)
Withthesteamdeliveryadjustment,itispossibletoselectthesteamquantitythat
youwishduringyourcleaningfromminimumtomaximum.
PRESSURE GAUGE (8)
Thepressuregaugeindicatestheoperatingpressureofthesteamcleaner.Ifthe
needle is in the green section, the product is operating normally. If the needle
is continuously in the red section, reduce amount of steam being used, if this does
not correct the problem the steam cleaner may require service. Please contact
the place of purchase for service.
USING THE ACCESSORIES
CONNECTING THE ACCESSORIES
Inserttheplugattheoppositeendofthesteamgun/hose(11)totheconnecting
outlet(10)alltheway,makingsureitcannotbepushedinfurther.Connectthe
handleofthesteamgun(11)totheextensiontubes(12),pressingthelockingbut-
tonlightlyuntilthebuttonsnapsin.Alltheaccessoriesareconnectedthesameway.
Theangleadapter(16)isusedfortherectangular(13)andtriangular(14)brush
in the following way: hold the brush in one hand with the bristles pointing down while
with the other hand inserts the angle adapter into the brush pointing it downward.
Afterthis,turntheangleadapter180ºsothatthelineontheangleadapterand
thedotonthebrushlineup.Whenthelineandthedotlineup,youcanadjust
thegreylevertothemiddleposition(locked)tolockthebrushsothatitcannot
move,ortothepositionclosesttoyou(rotate)toallowforthebrushheadto
rotate.Toremovethebrush,makesurethegreyleverisinthepositionfurthest
fromyou(assemble)andmakesurethelineontheadapterandthedotonthe
brushlineup.Rotate180ºtoremove.