Installation Guide

Relay2 RA340 Smart Access Point Hardware Installation Guide
PRDT-0055 © Relay2, Inc. 2019. All rights reserved.
2
Opening the Package
• Please ensure that all ordered optional accessories are included in separate accessory box.
• Please check the packaging list first. If there are any missing or broken parts, please contact the authorized
distributor of Relay2, Inc.
Safety
• Read the Quick Installation Guide carefully before installation and power up.
• To avoid over-heating, make sure the AP allows for proper heat dissipation and leave enough room for air
circulation.
• Do not directly touch the bottom of AP to avoid scalding. When the AP is in operation, depending on the
environment temperatures, the surface temperature of back cover might get hot.
• Any unauthorized modification of the product structure and safety design is not allowed.
Before you start
• Before installation, signal detecting test can be used to determine the best installation position.
• Keep your body at least 20cm away from the AP during installation and operation.
• Install the AP at least 1M distance from any metal obstructions to avoid radio signal affected by metal shielding.
• To avoid radio interference, keep the device away from magnets or magnetic fields, ie: do not place near
microwave, refrigerator ...etc.
Power Source Options
• The RA340 access point can be powered by using the external Relay2 AC Adapter, PoE+ Injector (both sold
separately), or a third-party PoE+ switch.
Warranty
• Please provide the device model, MAC address and serial number shown on the tag of the side panel.
• The warranty does not cover product that has been opened without authorization from Relay2 Inc.
• Reasonable repair and shipping cost will be charged for product fault or damage caused by using non-Relay2
accessories or improper operation.