Installation Guide

PRDT-0055 © Relay2, Inc. 2020. All rights reserved.
Relay2 RA320 Smart Access Point Hardware Installation Guide
Verify RA320 Functionality
First check if the status LED is solid green. During first boot, it is highly likely that the AP is automatically updating
its firmware, indicated by an amber blinking status LED. The status LED should turn solid green after the upgrade
process has finished (normally within a few minutes). See LED indicator table below for more details.
Verify access point connectivity – use any 802.11 client device to connect to the RA320 AP and verify network
connectivity using the client device web browser by going to a well-known web page.
Check network coverage and confirm good signal strength in the desired coverage area.
States
AP Status LED Display
State 1: Power On
Solid Green
State 2: R2OS starting
Amber Solid for 2 seconds
State 3: R2OS initializing
Amber blinking
State 4: Radio up and ready
Not affected
State 5: SCM connecting
Green blinking
State 6: CWCL connecting
Green fast blinking
State 7: AP up and running
Green solid
State 8: AP Image upgrade
Amber blinking
State 9: AP Radio down
Not affected
Table 1 RA320 LED booting states