Installation Guide

Table Of Contents

Relay2 RA320 Smart Access Point Hardware Installation Guide

Opening the Package

 Please ensure that all ordered optional accessories are included in separate accessory box.

 Please check the packaging list first. If there are any missing or broken parts, please contact the authorized

distributor of Relay2, Inc.

Safety

 Read the Quick Installation Guide carefully before installation and power up.

 To avoid over-heating, make sure the AP allows for proper heat dissipation and leave enough room for air

circulation.

 Do not directly touch the bottom of AP to avoid scalding. When the AP is in operation, depending on the

environment temperatures, the surface temperature of back cover might get hot.

 Any unauthorized modification of the product structure and safety design is not allowed.

Before you start

 Before installation, signal detecting test can be used to determine the best installation position.

 Keep your body at least 20cm away from the AP during installation and operation.

 Install the AP at least 1M distance from any metal obstructions to avoid radio signal affected by metal shielding.

 To avoid radio interference, keep the device away from magnets or magnetic fields, ie: do not place near

microwave, refrigerator ...etc.

Power Source Options

 The RA320 access point can be powered by using the external Relay2 AC Adapter, PoE Injector (both sold

separately), or a third-party PoE+ switch.

Warranty

 Please provide the device model, MAC address and serial number shown on the tag of the side panel.

 The warranty does not cover product that has been opened without authorization from Relay2 Inc.

 Reasonable repair and shipping cost will be charged for product fault or damage caused by using non-Relay2

accessories or improper operation.