Tus neeg siv phau ntawv

10/2021 · User Manual Version 1.0 · valid from firmware version 3.1.22
31
WEBLOG 250
four times with about one second pause between each operation. Then connect the USB memory stick to the
front USB of the WebLog. The WebLog searches for a file on the stick with the name “update.img“.
If the message appears that the USB stick has not been recognized, you should remove the stick and connect
it again. The following flashing procedure works similar to the above described procedure.
You can reset an already used WebLog device to factory defaults if you want to install it into a new plant or
site. This erases all log intervals, exports, exports schedules and the list of meters. The complete log database
can also be erased on request if the data records are no longer needed. This speeds up the system due to
less database operations need to be performed by the CPU.
The button “Factory Reset” resets the configuration of the WebLog to factory defaults.
Please note that the button “Factory Reset” is not available in the Web browser interface!
The system reboots after an additional safety query and the decision whether the complete log database shall
be deleted. Directly after the restart a setup wizard is executed which leads the administrator through the
most important system settings.