Safety Information

interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

 Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for

compliance could void the user‘s authority to operate the equipment.

FCC RF Exposure Information (SAR)

This device is designed and manufactured not to exceed the emission limits for exposure to radio

frequency (RF) energy set by the Federal Communications Commission of the United States.

During SAR testing, this device is set to transmit at its highest certified power level in all tested

frequency bands, and placed in positions that simulate RF exposure in usage near the body with

the separation of 5 mm. To reduce exposure to RF energy, use the hands-free option with the

built-in speakerphone, or an optional set of headphones, or other similar accessories. Although

the SAR is determined at the highest certified power level, the actual SAR level of the while

operating can be well below the maximum value. This is because the device is designed to

operate at multiple power levels so as to use only the power required to reach the network. In

general, the closer you are to a wireless base station antenna, the lower the power output.

The FCC has granted an Equipment Authorization for this model device with all reported SAR

levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on

this model device is on file with the FCC and can be found under the Display Grant section

of www.fcc.gov/oet/ea/fccid after searching on FCC ID: 2AMBHRW2266.

The exposure standard for wireless employs a unit of measurement known as the Specific

Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg averaged over one gram of

tissue. The highest SAR value reported under this standard during product certification is Head –

1.1

W/Kg and Body – 1.

W/Kg.

IC Notice

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject

to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired

operation of the device.