SDS
Page 3 of 6
O COO O OCO
O COO: Use with adequate ventilation to ensure exposure levels are maintained
below the limits provided below. Use local exhaust ventilation, and process enclosure if necessary, to control airborne dust.
Ensure eyewash/safety shower stations are available near areas where this product is used.
O :
C
C
C
O
O
O
Odorless Mineral Spirits
(Stoddard Solvent )
8052-41-3
TWA 100 ppm
TWA 500 ppm
(2900 mg/m
3
)
TWA 350 mg/m
3
C
1800 mg/m
3
[15-
minute]
NE
Mineral Seal Oil -
Distillates (petroleum),
hydrotreated middle
64742-46-7
TWA 5 mg/m
3
[8-
hour]
TWA 5 mg/m
3
[8-
hour]
TWA 10 mg/m
3
[15-
minute]
NE
NE = Not Established. NIC = Notice of Intended Change See Section 16 for Definitions of Terms Used.
Currently, International exposure limits are established for the components of this product. Please check with competent
authority in each country for the most recent limits in place.
The following information on appropriate Personal Protective Equipment is provided to assist employers in complying with
OSHA regulations found in 29 CFR Subpart I (beginning at 1910.132) or equivalent standard of Canada, or standards of EU
member states (including EN 149 for respiratory PPE, and EN 166 for face/eye protection), and those of Japan. Please
reference applicable regulations and standards for relevant details.
O OCO:
If exposure limits are exceeded, use only respiratory protection authorized in the U.S.
Federal OSHA Respiratory Protection Standard (29 CFR 1910.134), equivalent U.S. State standards, Canadian CSA
Standard Z94.4-93, the European Standard EN149, or EU member states. Oxygen levels below 19.5% are considered IDLH
by OSHA. In such atmospheres, use of a full-facepiece pressure/demand SCBA or a full facepiece, supplied air respirator
with auxiliary self-contained air supply is required under U.S. Federal OSHA’s Respiratory Protection Standard (1910.134-
1998) or the regulations of various U.S. States, Canada, EU Member States, or those of Japan. Air-purifying respirators with
dust/mist/fume filters are recommended if operations may produce mists or sprays from this product.
OCO:
Splash goggles or safety glasses with side shields recommended.If necessary, refer to U.S. OSHA 29
CFR 1910.133, Canadian Standards, and the European Standard EN166, Australian Standards, or relevant Japanese
Standards.
OCO:
Compatible protective gloves recommended. Wash hands after removing gloves. If necessary,
refer to U.S. OSHA 29 CFR 1910.138, the European Standard DIN EN 374, the appropriate Standards of Canada,
Australian Standards, or relevant Japanese Standards.
O OCO:
Use body protection appropriate for task. Coveralls, rubber aprons, or chemical protective clothing
made from natural rubber are generally acceptable, depending upon the task. If necessary, refer to appropriate Standards
of Canada, or appropriate Standards of the EU, Australian Standards, or relevant Japanese Standards. If a hazard of injury
to the feet exists due to falling objects, rolling objects, where objects may pierce the soles of the feet or where employee’s feet
may be exposed to electrical hazards, use foot protection, as described in U.S. OSHA 29 CFR 1910.136.
C CC O
: Not Established OO : Not Established
CC C: <1 (water=1) O : Dispersible
O C : Not Established : 7 - 9
OO O: Pleasant
C OO COO: product is a thick creamy liquid with a pleasant odor
C
: Stable.
COOO OC:
When burned: CO
2
, CO, or Hydrocarbons may be omitted
C C CO:
Strong oxidizers such as peroxides
O OO:
Will not occur.
OC:
0.00 Reportable VOC (CARB)0.00 Reportable VOC (CARB)0.00 Reportable VOC (CARB)0.00 Reportable VOC (CARB)