AC Controller--ShowDoc

4. Press the key manually to close, press the key briefly to disconnect the relay
5. Configuration Port
6. AC output _
7. AC output +
8. AC input _
9. AC input +
1. please follow the correct wiring identification diagram for wiring. Incorrect wiring may cause equipment
damage
2. please cut off the power supply when wiring. Live wiring may cause electric shock
3. please strictly equip the load and do not overload
4. the equipment shall be installed without direct sunlight, and shall be protected from moisture, dust and rain
5. in case of equipment failure or doubt, please contact the manufacturer
Before test, please make sure install LoRa Antenna.
Short press button 1, turn on the relay
Short press button 1, turn off the relay
The equipment antenna interface adopts standard SMA and the specification of external thread and internal hole.
During installation, pay attention to avoid metal and strong interference equipment. If the installation
environment is poor, it is recommended to use a sucker antenna with feeder for installation.
When the equipment is started, the default relay is disconnected. Report immediately when the switch status
of equipment relay is changed.
When the system reports the cycle time, it reports the data.
Recommend configuration tool SensorTool for reference.
Parameter configuration mainly includes two aspects: sensor correlation: acquisition cycle and reporting cycle,
and wireless LoRa related parameters.
The default connecting period is 10s, and you can set 1s for the shortest period, and also you can set 65553s for
the longest period. The shorter period, the faster respond, but power consumption is higher.
1.5.Attentions
2. Function
2.1.Function of Button 1
2.1.2. Function of Button 2
2.5.Antenna
2.6.Data uploading logic
3. Paremeter Configuration
3.1.Connecting Period
3.2. Uploading Period