Operating instructions

16
Stamping
Stamping will be triggered by pressing the red trigger, which is located
in the grip.
Depending on the impression selected, the impression will have one
or two lines. The position of the two lines, relative to the base of the
stamp, can be seen in the illustration below.
Stamping may be protected by a password. In that case
the correct password must first be entered.
To block stamping again, press [ MODE ] repeatedly
until 'CLOSE' appears in the menu bar.
Pressing [ CLOSE ] will block stamping.
If you need more information, please contact your dealer.
• The ink in the ink cartridge is harmful!
Never hold jetStamp gainst a person’s face!
• The cable lenght of an external trigger amount to max. 1 m
• If you apply a higher voltage than 1V to the socket
you risk damage of the device!
Stamping is not possible under the following circumstances:
• When the battery is discharged - the display shows
“EMPTY BATTERY NO IMPRINT POSSIBLE”
• In Setup or Setting mode
• When jetStamp is in the charging station
•
Printing is blocked - the display shows “IMPRINT BLOCKED” :
The blockade can be released by pressing [ QUIT ]
(see also page 23, menu item 'BLOCK IMPRINT')
ORDER 00000000
11. Jul 2006 14 : 36
max. width
of both print lines
i
Note
first print line
second print line