Operating instructions

Numbering device - setting starting point or figures :

Press [ NEXT ] if necessary repeatedly, until the display shows

“INPUT - NUMBERER 1” “INPUT - NUMBER 1” or

INPUT - NUMBERER 2

* INPUT - NUMBER 2 *

* Only available with a customer-specific impression (P:26 ... P:29),

which has been prepared using PC-Set

Press [ VARY ] to select the first position of the entry

Set this digit by using [ INC ] to increase, or [ DEC ] to decrease it

With the [ LEFT ] and [ RIGHT ] buttons, you can move to the

other positions. They can be set using [ INC ] and [ DEC ]

To exit the setting press [ RETURN ]

Press [ RETURN ] again to exit the menu. The selected

impression is displayed again, and jetStamp is ready for use

Numbering device - additional functions

Increasing and / or decreasing numbering between limits.

Press [ MODE ] if necessary repeatedly, until the following functions

appear in the menu bar:

[ N1 MAX ] = upper limit is activated (pressing this button again

displays the upper limit)

[ N1 MAX ] = upper limit is de-activated

[ N1 MIN ] = lower limit is activated (pressing this button again

displays the lower limit)

[ N1 MIN ] = lower limit is de-activated

[ N1 CLR ] = all limits de-activated

[ COUNT ] =

increases or decreases the counter reading by one step

[ CLEAR ] = sets the counter back to the limit

For further notes on additional numbering-device functions, see page 22