Operating instructions

Setting numbering device or figures

The numbering device is used for the successive numbering of forms.

Numbering can be increasing or decreasing. Further, various functions

of the numbering device can be coupled together, e.g. repetition, zeroing,

counting, activation of a minimum or maximum value, advance step, etc.

Before the numbering device can be set, an impression, which uses the

numbering device or figures, must be selected (see pages 9 / 10).

Selecting the numbering device:

Press the [ MODE ] button, if necessary repeatedly, until

the menu item “NO / TXT” appears in the menu bar.

Pressing [ NO / TXT ] then activates the menu.

This menu may be protected by a password. In that case

the correct password must first be entered.

Depending on the impression selected, the following functions may be

available. By pressing [ NEXT ] , you can scroll through them.

¥ INPUT - REPETITION = for setting the repetition factor

¥ INPUT - NUMBERER 1 or INPUT - NUMBERER 2 * =

for entering the starting point of a numbering device

¥ INPUT - PRE TEXT = for selecting the pre-text

NPUT - NUMBER 1 or INPUT - NUMBER 2 * = for setting figures

* These functions are only available with a customer-specific

impression (P:26 ... P:29), which has been prepared using PC-Set

Setting the repetition factor (INPUT - REPETITION):

Press [ NEXT ] if necessary repeatedly, until the display

shows “INPUT - REPETITION”

Press [ VARY ] to select the units position of the entry

Set the units position by pressing [ INC ] to increase

the setting, or press [ DEC ] to reduce it

By pressing the [ LEFT ] button, you can move to the tens

position, which can also be set with [ INC ] or [ DEC ]

Press [ RETURN ] to exit the setting

Note