Operating instructions

12
Setting time and date
To set the time and date, an impression must first be selected that contains
the date, or date and time as appropriate.
First select an impression that contains the date, or date and time
as appropriate (see also pages 8 and 9).
Press [ MODE ] if necessary repeatedly, until the menu item
“CLOCK” is displayed
Press [ CLOCK ] to select the required menu item
The display shows “INPUT - TIME 1”
* and below it
you will see the time currently set
This menu may be protected by a password.
In that case the correct password must first be entered.
Press [ VARY ] to select the minutes figures and set the
minutes by pressing [ INC ]
Press [ NEXT ] to select the hours figures and set the
hours by pressing [ INC ]
Press [ RETURN ] and then [ NEXT ] to change
to the date display (display shows “INPUT - DATE 1”
*)
Press [ VARY ] to select the year figures and set the year
by pressing [ INC ]
Press [ NEXT ] to change to the month display and use
[ INC ] to set the month
Press [ NEXT ] to change to the days figures and use
[ INC ] to change the setting
Press [ RETURN ] if necessary twice, to exit the menu.
The impression selected will be displayed, and the stamp is ready for use
* When using a customer-specific impression (P:26 ... P:29) ,
you can change to “INPUT - TIME 2 or “INPUT - DATE 2”
at this point by
pressing [ NEXT ] (see page 10)
i
Note