Operating instructions

17
Stamping
Stamping will be triggered by pressing the red trigger, which is located
in the grip.
Depending on the selected imprint, the imprint will have one or two lines.
The position of the two lines can be seen in the illustration below.
• Stamping may be protected by a password. In that case
the correct password must first be entered.
To block stamping again, press [ MODE ] repeatedly
until 'CLOSE' appears in the menu bar.
Pressing [ CLOSE ] will block stamping.
• Avoid the dry up of the nozzles of the ink cartridge:
With longer breaks, jetStamp should be placed in the
charging station
The ink in the ink cartridge is harmful!
Never hold jetStamp against a person’s face!
Stamping is not possible under the following circumstances:
• When the accumulators are discharged, the display shows
“EMPTY BATTERY NO IMPRINT POSSIBLE”
• In Setup or Setting mode
• When jetStamp is in the charging station
• Printing is blocked - the display shows “IMPRINT BLOCKED” :
The blockade can be released by pressing [ QUIT ] (see also
page 24, menu item 'BLOCK IMPRINT')
ORDER 00000000
21. JAN 2009 14 : 36
max. width
of both print lines
i
Note
first print line
second print line