Operating instructions

22
Troubleshooting
Display Cause Recommendation
IMPRINT Time allowed by ‘Block Imprint’ Press [ QUIT ] :
BLOCKED has expired, disappears trigger jetStamp is then ready
has been pressed for use again
WRONG Wrong base station, Press [ QUIT ] :
STATION jetStamp needs an intelligent Error message
base station disappears and previous
display reappears
Error 04 Memory error Press [ QUIT ]
Error 09 - Sensor or motor defective Press [ QUIT ]
- print carriage blockade and start stamping again
• If the Reset button is pressed, various settings are lost,
e.g .date and time and the battery charge indication.
jetStamp must then be placed in the charging station for
about 3 hours to synchronise the state-of-charge indicator.
• If the battery has been discharged too far, the charging
process may cause confused signs to appear in the display.
Pressing the Reset button will cure this condition.
• To operate the Reset button, insert a straightend paper clip
or similar object through the opening in the rear face
of the stamp
Reset button
i
Note